Pot Light Installation Cost in Toronto: What Drives the Price

Pot lights (recessed LED lights) are the most requested lighting upgrade we do in Toronto homes. Cost is driven per fixture, not per room, so the number of lights and the ceiling you are cutting into decide most of the price.

For the service itself, see Pot Lights & LED Lighting in Toronto & the GTA.

How pot light pricing works

Every pot light job is priced after we see the space — ceiling access, fixture choice and patching all change the cost. You get one written price before any work starts.

What pushes the price up

• **Ceiling material.** Drywall is straightforward. Plaster, hardwood, coffered and cathedral ceilings take longer and cost more.
• **No existing wiring.** If there is no light and no wire run to work from, new circuits must be pulled from the panel.
• **Obstructions.** Joists, ducts, plumbing and existing wiring in the ceiling cavity all add labour.
• **Finished ceilings below occupied rooms**, where access is only from below.
• **Dimming and control.** Standard dimmers are inexpensive; a Lutron scene-controlled layout is a different scope of work.
• **Outdoor and soffit locations**, which need weather-rated housings.

What brings it down

• An existing ceiling fixture and wire run to reuse
• Open ceilings during a renovation or an unfinished basement
• Doing the whole floor in one visit rather than room by room

How many pot lights do you need?

It depends on room size, ceiling height and what the room is for — a kitchen work surface needs different spacing than a living room. We lay the pattern out on site before cutting anything, so you see the spacing first.

What is included

Layout, fixtures and trims, dimmer, clean cutting, wiring and switching, and code-compliant installation by ESA/ECRA licensed electricians. Where the work requires a notification, the ESA permit and certificate are ours to handle.